Page 1 of 1
25-06 Coyote load
Posted: Thu Jan 27, 2011 8:49 am
by NickNielsen
Anyone have a good load for a 25-06 for coyotes. Was thinking about 75 grain V-Max's but the more I read, the heavier bullets seem to be more accurate for this caliber. Any suggestions? Thanks.
Re: 25-06 Coyote load
Posted: Fri Jan 28, 2011 7:44 am
by Optimax90
Im shooting a 100gr Barnes TSX out of mine and it shoots good, anything lighter didn't pattern as well.... My load is running 3350fps and no pressure. With the Barnes, you might get away from massive exits cause the fact it hold together so well.....
Re: 25-06 Coyote load
Posted: Fri Jan 28, 2011 1:32 pm
by leadbiscuit
I had a sporter weight savage for a short time. It shot the 75 grain v max pretty well. RL19 and H4350 were the best powders in mine. RL19 had a slight accuracy edge. I don't have the exact loads around anymore.
Re: 25-06 Coyote load
Posted: Mon Jan 31, 2011 11:21 am
by NickNielsen
Thanks Guys. I'm going to try a 90 grain HP and IMR4350 for starters. I'll post results. Thanks again for the input.
Re: 25-06 Coyote load
Posted: Wed Feb 02, 2011 12:35 pm
by kflan22
100 grain hornady interlock and 57 grains RL19. 3350 fps
In and out with little damage from my experience. Sure knocks them flat though!